Glong 0.5HP Water Pump (110V): Home Water Pressure Guide
By Maintenance Depot Plumbing Team · Last reviewed
Quick answer
The Glong GMP-60/110 is a 0.5HP, 110V water pump commonly used to boost water pressure or pump from a tank in small to medium homes. Fit a check valve, unions and a dedicated grounded circuit.
Low water pressure is a common problem in Jamaica, especially for homes on hillsides or relying on storage tanks. The Glong 0.5HP water pump (GMP-60/110) is a compact, 110V pump suited to boosting water supply for a typical household.
Specs at a glance
| Spec | Detail |
|---|---|
| Product | Water pump |
| Brand / model | Glong GMP-60/110 |
| Power | 0.5HP |
| Voltage | 110V |
| Typical use | Household pressure boost, tank-to-house pumping |
Is a 0.5HP pump right for you?
A half-horsepower pump is a common choice for:
- Small to medium homes
- Pumping from a ground tank to the house
- Boosting pressure to showers and upstairs bathrooms
For large homes, multiple floors or long pipe runs, ask us about higher-capacity options.
Installation tips
- Mount the pump on a solid, level base, sheltered from rain and direct sun.
- Keep the suction line as short and straight as possible.
- Fit a foot valve or check valve on the suction side so the pump stays primed.
- Install ball valves and unions on both sides so the pump can be serviced.
- Use a dedicated, properly grounded 110V circuit. Have an electrician do the wiring.
- Prime the pump (fill it with water) before first start-up.
Protect your pump
- Never run it dry. A float switch or low-water cut-off in the tank is a good investment.
- Use a surge protector, since power fluctuations can damage motors.
- Check for leaks and unusual noise regularly.
Maintenance Depot stocks PVC unions, ball valves and fittings to complete your pump installation.
Frequently asked questions
Is 0.5HP enough for my house?
It is a common choice for small to medium homes. Larger homes, multiple floors or long pipe runs may need more capacity.
Why does my pump lose prime?
Usually a leaking suction line or a failed foot or check valve lets air in.
Can a pump run without water?
No. Running dry can damage it quickly. A float switch or low-water cut-off helps protect it.